- This topic has 2 replies, 1 voice, and was last updated 15 years, 5 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
@venmc
AdministratorThe switch is mounted on the right side bottom frame rail. You’ll see the brake lines go in one side and out the other and an electrical connection on top. Its pretty rare for those switches to fail so I’d check the electical connection first.
loop-single-reply.php
@venmc
AdministratorI had same issue; The tail pipes had cooked the wires and contacts on top of the switch. Got some heat resistant wire and contacts went back couple of inches into the existing wire and came back to switch with new
loop-single-reply.php
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.