- This topic is empty.
Viewing 1 post (of 1 total)
-
Posts
-
@unknown
On my quest to replace my final drive belt I have removed the clutch plates and when I spin the inner Hub that connects to the transmission shaft the outer hub that the drive belt from the engine attaches to wobbles a little bit it is not drastic, is that normal? or is that mean there’s a bearing somewhere going bad? I’m talking about spinning the inner Hub that turns the final drive belt pulley See picture my finger is on it
loop-single-reply.php
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.