- This topic has 10 replies, 2 voices, and was last updated 14 years, 5 months ago by
.
-
Posts
-
@dougie693
Subscriberwent to replace fork seals that are leaking, but whoever assembled the forks used red thread locker on the dust boot covers and they cannot be removed now wothout destroying them…… i called pro-one to order a new set before ruining the ones on there now and they are on national back order for 60 to 90 days … wtf, any suggestions or know of any other covers that will work with the threaded lowers ?
loop-single-reply.php
@venmc
AdministratorI think there are some from Drag Specialties that’ll work. I’ll check with Jim (Head Janitor / parts guru).
loop-single-reply.php
@dougie693
Subscriberthanks for looking into it
loop-single-reply.php
@dougie693
Subscriberstephen any luck on the fork dust covers ?
loop-single-reply.php
@headjanitor
EditorDrag is backordered on part# DS-174781 but it’s available on ebay: http://cgi.ebay.com/ebaymotors/HARLEY-41mm-FORK-SEAL-KIT-SOFTAIL-FL-_W0QQcmdZViewItemQQitemZ290556750917QQptZMotorcyclesQ5fPartsQ5fAccessories
loop-single-reply.php
@dougie693
Subscriberthe ones on e-bay have the set screw they arent the threaded ones that you used on your bikes, i called pro-one and they wont work and ds-174781 is a seal kit, thats not what i need i need the pro one dust boot covers because whoever assembled the front end used red thread locker on them and now they cant be removed without destroying them
loop-single-reply.php
@venmc
AdministratorAh sorry… I was thinking you were looking for the seals. so back to the original problem. I assume you’ve tried a Boa wrench. Also Pro-One has some other styles that fit. Are they out of all of them?
loop-single-reply.php
@dougie693
Subscriberyeah unfortunately they are back ordered on all styles
loop-single-reply.php
@venmc
AdministratorI have a set of pro-one lower legs in storage and will sell you the caps… if you will send the damaged caps back to me so I can send them out to be striped, polished and re-chromed.
loop-single-reply.php
@venmc
AdministratorJim (head Janitor) says heat up the caps before using the soft wrench. The heat will re-liquify the red loc-tite and you will be able to remove the caps.
loop-single-reply.php
@dougie693
Subscriberok i’ll try the heat, if that doesn’t work i’ll buy the caps from you….. thanks
loop-single-reply.php
- You must be logged in to reply to this topic.