- This topic has 2 replies, 1 voice, and was last updated 9 years, 11 months ago by
.
-
Posts
-
@sittn-duck
SubscriberI went to start it up and all I get is starter turning noise but no engagement to ring gear. I took off the primary cover and I have a belt drive…wow, did not know that. Anyway when i hit the button the starter pinion gear comes out and engages with the gear on the clutch pack and I hear the starter turning…buzzz…but the pinion gear does not turn at all. So i figure I got to remove the starter and replace or rebuild. I disconnected the battery, I disconnected the wires to the starter. I took out the jackshaft bolt, gear…the stuff on that end.
I see one bolt on the front side of the starter. Where is the other bolt located?I found it. :blush:
This looks like the starter on my raider, is it the same or do you know if it will work?
http://www.2wheelpros.com/spyke-supertorque-starter-2513882.html?o=12104201&gclid=CjwKEAjw8LOsBRDdub-swPW8riISJAAnmS01GnOIxaCVt6vR0eL22h_zoPO9Y86Po752mY6hHFVVwxoCsvrw_wcBloop-single-reply.php
@venmc
AdministratorYes its a Spyke starter. I’ll get Jim (head janitor) to login he can help you.
loop-single-reply.php
@sittn-duck
SubscriberThanks, the local custom shop had one and picked it up.
Works good…I hope it lasts a while.
If a kickstart was put on this bike would it be possible to turn over the motor fast enough to start it?loop-single-reply.php
- You must be logged in to reply to this topic.