- This topic has 4 replies, 1 voice, and was last updated 13 years, 6 months ago by
.
-
Posts
-
@jleh01
SubscriberMy speedometer stopped working while I was cruising, it stayed at 0 for a while then it would show numbers (not the correct speed though) now it just stays at 00. I pulled the sensor out to see if there were any shavings on it there were none but it looks like the gear was rubbing it a little. Is that normal for the sensor? Any other ideas? Whats the easiest way to get to the connector if I replace it? Looks like the wire goes behind the oil tank assuming thats where the connector is.
loop-single-reply.php
@venmc
AdministratorNext pull that back of the speedo carefully push the connector back onto the fingers and see if it wakes up. If yes put a piece of foam rubber behind the connector before you put the back plate back on.
loop-single-reply.php
@jleh01
SubscriberTried what you said, seems connector are hot glued onto the fingers, didn’t see any problem there.
loop-single-reply.php
@venmc
AdministratorI’d do a continuity check to make sure you dont have any shorts and if everything checks out then call dakota digital and replace the speedo head.
loop-single-reply.php
@jleh01
SubscriberBeen a while since I’ve been on here but would like to let everyone know that I replaced the speed sensor and everything works great. Also cut wires near sensor and installed a plug if I ever have to replace it again. Thanks for your help.
loop-single-reply.php
- You must be logged in to reply to this topic.