Vengeance

998 American Hotrod Motorcycles

  • Home
  • About
  • Friends
  • Owners Forum
  • Press
  • Ride on JDO
  • Runaway American Dream
  • Shop
  • The 998
  • Timeline
  • Tribute
  • vTube
Home » Topics » Re: 04 Raider, changing primary and points covers

Re: 04 Raider, changing primary and points covers

Home › Forums › Parts & Technical Info › Re: 04 Raider, changing primary and points covers

  • This topic is empty.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • August 31, 2009 at 8:09 am #1905
    @unknown

    High humidity areas are the only places Ive heard of needing to vent the primary. An inexpensive alternative for venting would be to install 1/4-3/8 inch spacers behind the inspection and derby cover. For a little more ventilation you can drill through the bolt holes for the primary chain adjuster. Ive seen these drilled up to 1/2 inch. Also keep in mind that if you vent your primary in this way youll want to be careful not to get excessive water inside the primary. Be sure to remove the drain plug too.

    loop-single-reply.php
  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Log In

Runaway American Dream

The Runaway American Dream is based on the roller coaster ride of the amazing startup and eventual implosion of Vengeance Motorcycles during the Chopper Boom at the turn of the 21st century.   In … more

Contact Us

  • Vengeance Motorcycles
  • P.O. Box 506
  • Newport Beach, CA 92661
  • info@venmc.com

Owners Login

Lost your password?

Copyright © 2025 VengeanceMotorcycles.com · Log in