- This topic has 2 replies, 2 voices, and was last updated 14 years ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
@rock-n-roll-bob
Subscriber
loop-single-reply.php
@headjanitor
EditorIt’s an Arlen Ness Radius control. Check out item #200530410018 on ebay. From what I’ve read Arlen uses a 3/4″ plunger for his dual disc master cylinders and a 5/8″ for single. You’ll need to disassemble yours to see which it is. Keep in mind that since these were made overseas the plunger and seals may be slightly different than HD so you may need to go thru Ness for a rebuild kit. If a stock replacement works Drag Specialties should have the kits in stock. Not bad for a Fresh Boarder, huh?
loop-single-reply.php
@rock-n-roll-bob
SubscriberB) Thanks so much ..very cool was a real big help keep up the good work ….
loop-single-reply.php
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.